11/14/2023 0 Comments R wipe and clean registration codeNot everyone knows that the reload command permits to schedule a reboot system for instance, to plan a night router restart or during a .To check for OUI on FC switches use below commands: MDS#show wwn switch MDS#show fcid company-id-from-wwn swwn_from_previous_output For example: MDS# show wwn switch Switch WWN is 20:00:xx:xx:xx:xx:yy:zz MDS# show fcid company-id-from-wwn 20:00:xx:xx:xx:xx:yy:zz Extracted oui: 0x003A9C Resolution In the configuration wizard, enter the basic switch settings: Admin password Switch name Out-of-band management configuration Default …2. During the boot, if you receive the prompt “Abort Auto Provisioning and continue with normal setup? (yes/no) ”, you should respond yes to proceed. Otherwise, enter the reload command for the standby supervisor from a vsh session on the active supervisor, specifying the force-dnld option.Cisco Nexus 9000 Series NX-OS Command Reference (Configuration Commands), Release 10.2(x) 16/Feb/2022 Cisco Nexus 9000 Series NX-OS Command Reference (Show Commands), Release 10.2(x) 16/Feb/2022The system reboots and enters the configuration wizard. no shutdown Nexus-2: Nexus-2(config)# interface mgmt 0 Nexus-2(config-if)# .If the supervisor is at the loader prompt, try to use the boot command to continue the boot procedure. Cisco vPC is a feature for Nexus series switches that allows to configure a. non-interruptive (Optional) Non-Interruptive install. noswitchover (Optional) Exit right before reload during install. no-reload (Optional) Exit right before reload during install.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |